-
E-mail
bj_tprs@163.com
-
Phone
13311288638
-
Address
2nd Floor, Building 1, Zhongli Science and Technology Park, Third Street, Shangdi Information Industry Base, Haidian District, Beijing
Product Categories
Beijing Topraysheng Measurement and Control Technology Co., Ltd
RS-9200 Vibration Speed Sensor
NegotiableUpdate on 12/03
- Model
- Nature of the Manufacturer
- Producers
- Product Category
- Place of Origin
Overview
The RS-9200 vibration velocity sensor is mainly installed on the bearing covers of various rotating mechanical devices, such as turbines, compressors, fans, and pumps. It is an electromagnetic sensor that outputs voltage by cutting magnetic field lines with a moving coil, and therefore has the characteristics of not requiring power supply during operation and easy installation. The RS-9200 (16699) vibration speed sensor can directly replace the BENTLY 9200 (16699) speed sensor. After being connected with vibration and intensity scales, various vibration displacements, velocities, etc. can be measured. The vibration of the rotor supported by rolling bearings will be sufficiently transmitted to the bearing seat. The speed sensor installed on the bearing seat or very close to the bearing housing outputs voltage by cutting magnetic lines through internal motion coils, providing signals to monitoring instruments for predicting and alarming mechanical faults.
Product Details
The RS-9200 vibration velocity sensor is mainly installed on the bearing covers of various rotating mechanical devices, such as turbines, compressors, fans, and pumps. It is an electromagnetic sensor that outputs voltage by cutting magnetic field lines with a moving coil, and therefore has the characteristics of not requiring power supply during operation and easy installation. The RS-9200 (16699) vibration speed sensor can directly replace the BENTLY 9200 (16699) speed sensor. After being connected with vibration and intensity scales, various vibration displacements, velocities, etc. can be measured. The vibration of the rotor supported by rolling bearings will be sufficiently transmitted to the bearing seat. The speed sensor installed on the bearing seat or very close to the bearing housing outputs voltage by cutting magnetic lines through internal motion coils, providing signals to monitoring instruments for predicting and alarming mechanical faults.
Technical Specifications
tFrequency response: 5Hz~1000Hz (-3db)
10Hz～1000Hz（－3db）
tSensitivity: 20.0mv/mm s-1 (500mV/inch/sec), ± 5%
(Measured at 80Hz and a speed of 10mm/s)
tAmplitude linearity:<3%
tImpact resistance: able to withstand a maximum peak acceleration of 50g
tLateral sensitivity:<5%
tWorking and operating temperature range: -30 ℃ to+120 ℃
tMaximum measurable displacement: 1mm (single peak value)
tOutput resistance: ≤ 1K Ω
tInsulation resistance:>2M Ω
tEnvironment: resistant to dust and moisture
tRelative humidity: 95% non condensing
tAppearance parameters: Height of 4 inches (102mm)
Diameter: 1.6 inches (41mm)
tWeight: 480g
µOrder model and specifications
A B C
RS-9200（16699）
Selection instructions
Installation angle/minimum operating frequency selection
0 1 0 °± 2.5 °, 5Hz (vertical installation type)
0 3 90 °± 2.5 °, 5Hz (horizontal installation type)
0 6 0°±100°，10Hz
When the sensor mounting surface is located below, it is set to 0.
B connector selection
0 1 installed at the top
0 2 installed on the side
0 3 terminal block at the top
Selection of C installation bolts
0 1/4-20UNC (Unified Standard Thread) Double Headed Bolt
0 2 1/4-28UNC (Unified Standard Thread) Double Headed Bolt
1 0 M10 × 1 double headed bolt
15 M10 × 1.5 double headed bolt
