Direct push soil sampling drilling rig in stock supply!

HBT-D505 Direct Push Soil Sampling Drilling Machine

1、 Product Introduction

HBT-D505 Direct Push Soil Sampling Drilling MachineIt is a lightweight soil collection drilling rig designed based on the reference of large hydraulic, gasoline, and pneumatic drilling rigs. Even inexperienced drilling personnel can operate with simple training. The sampling process is extremely simple, and only 1 to 2 people can complete the operation of the equipment. The entire drilling process does not require adding water, ensuring the quality of the sample obtained (no pollution, no disturbance).

Compared with conventional large drilling rigs,HBT-D505 Direct Push Soil Sampling Drilling MachineMore convenient to carry and easier to operate, non professionals can easily complete the operation of the equipment. In some project sites with low depth requirements (within 10 meters), relatively complex terrain, and difficult access for large equipment, using this equipment is very goodofchoice.

Compared to traditional hand drills,HBT-D505 Direct Push Soil Sampling Drilling MachineThe depth of drilling is deeper, the efficiency of sampling is higher, and the soil samples obtained are in their original state, basically undisturbed, and compressed (depending on the terrain). In projects with sampling depths exceeding half a meter and high requirements for soil sample quality (undisturbed, non compressed), the use of this equipment isvery goodchoice.

2、 Product Introduction Features

Fast footage, sampleMaintain the original state,No disturbance!

● Built in can be usedPVCSampling can be done through a sampling tube or directly!

Ideal depth for sampling conventional soil layers1-5Rice, the soft soil layer can reach up to 10 meters!

●Hand pulledStart button, stop trigger button, spring isolated seismic handle!

●PullerAdopting a more reasonable ergonomic design, it can be pressed by hand or stepped on by foot!

IIIProduct parameters

1Sampling depth1-10 meters (optional)

2vibratefrequency1300Times/minute

3movepower1.6 horsepower (7000rpm)

4engine typeSingle cylinder two-strokeengine

5oil consumptionnot more than0.6L/h

6weight20.2Kg (host)

7. The inner and outer diameters of the sample tube shall not be less than 35mm/40mm; Length not less than 1.00 meters per piece

8. Sampling depth, can be connected to a drill rod for one-time sampling without lifting the drill midway

9. The pulling device can be quickly pulled up at a speed of not less than 3.00 meters per minute

4Standard configuration

Gasoline poweredOne engine，A set of engine tool kit,One standard soil drill bit and one hard soil drill bit each, not less than1 meterofdrillpole2 piecesNot less than1 meterThe plastic20 sample tubes, 1 scraper, 1 rubber hammer, 1 vise, 1 headphone, 1 5M tape measure, 1 glove, and 1 cleaning brush,Extract 1 set of equipmentIndustrial plastic transport box2individual