Precision wind knife T-shaped

Using all stainless steel (SUS304 or 316L) material, it has stronger hardness, higher pressure resistance, and can better ensure precision;

The width of the air outlet can be adjusted (minimum 0.1mm, precision up to 0.1mm); The length can reach 2.4m (customized up to 3m).

Designed based on aerodynamic principles, it consists of an intake duct, splitter plate, gradually narrowing ventilation zone, narrow air duct, and other structures, particularly outstanding for low air resistance and average wind speed.

The main body generally has a pressure resistance of 5kgf/cm2, a maximum wind speed of 400m/s (using an air compressor can reach 400m/s), a temperature resistance of 250 ℃, and can be connected to a heater to blow out hot air.

Multiple air inlet diameters are available to meet different air volume requirements, with three options for air inlet on both sides, front, back, and top for easy installation.

In addition to being used for blowing water and drying, it can also be used as an isolation air curtain to reduce the loss of cold/hot air.

Specifications for Precision Wind Knife Models:

Example: DWK-G1-500-2-T1 (precision air knife, G1 (1 inch) pipe teeth for air inlet, 500mm length for air outlet, 2mm width for air outlet, top air inlet, one air inlet) ）

WDWK-G1-500-2-T1 (precision water jet, with G1 (1 inch) pipe teeth at the inlet, 500mm length and 2mm width at the outlet, top inlet, and one inlet) ）

DWK-T1 Precision Wind Knife Schematic Diagram

DWK-T1 Precision Wind Knife Dimensional Drawing

DWK-T2 Precision Wind Knife Schematic Diagram

DWK-T2 Precision Wind Knife Dimensional Drawing

DWK-T3 Precision Wind Knife Schematic Diagram

DWK-T3 Precision Wind Knife Dimensional Drawing

Notes:

※ Be careful not to collide with the cutting edge, and the medium used should avoid containing too coarse impurity particles to avoid causing damage to the cutting edge

Blockage or damage;

※ The width of the air outlet has been calibrated according to the customized requirements when the product leaves the factory. If it is necessary to make changes, please deliver it to the original supplier

Home or professional calibration should be carried out to avoid the weakening of product performance through self calibration.

Usage suggestion:

Rapid water removal, wind speed: 70~120m/s, air outlet width: 1~1.5mm

General water removal, wind speed: 50~80m/s, air outlet width: 1~1.5mm

Drying of water-based coating, wind speed: 40m/s, air outlet width: 5mm

Steam sterilization, wind speed: 70~150m/s, air outlet width: 0.3mm

Hot air drying, wind speed: 20~60m/s, outlet width: 2~5mm, temperature: 60 ℃~150 ℃

Hot air rapid drying, wind speed: 60~80m/s, outlet width: 2~5mm, temperature: 150 ℃~250 ℃