Continuous belt dryer for dried bamboo shoots

Dried bamboo shoots continuous belt dryer $n 1. Technical parameters: $n1. Drying temperature: 100-150 ℃ (adjustable); $n2、 Heat source: 0.5Mpa saturated steam; $n3、 The dryer has three layers, with an effective length of 10m, a network bandwidth of 2m, an effective drying area of 60m2, and a material operating speed controlled by frequency conversion; $n5、 Total installed power:? kw；$n6、 Equipment material: 304 stainless steel for material connection, and A3 steel for the rest;

　　Continuous belt dryer for dried bamboo shootstwoTheDW3-2-10Multi layer mesh belt dryer configuration and material parameter table:

　　1Heat source:0.5Mpasaturated steam；

Steam heat exchanger: 304 tube wrapped around stainless steel sheet/heat dissipation area of 900m2;

Inlet pipeline: A3 steel/δ=3mm;

Steam regulating valve: Made in Shanghai;

　　2TheDW3-2-10Multi layer mesh belt dryer host:

Square tube: A3 steel/304 stainless steel/80 × 80 × 4mm;

Outer cover plate: A3 steel/δ=1.2mm;

Internal sealing plate: 304 stainless steel/δ=1.5mm (fully welded inner wall);

Partition: 304 stainless steel/δ=1.5mm;

Slant plate: 304 stainless steel/δ=1.5mm; Insulation material: Rock wool/δ=80mm

Inlet and outlet hopper: 304 stainless steel;

　　3Transmission part:

Transmission motor: 1.5kw/Jiangyin Dazhong/5 units;

Gearbox: Changzhou Guomao/3 units;

Inverter: Shenzhen Yiqu/3 units;

Transmission shaft and tensioning device: 3 sets of 304 steel;

Bearings and shaft shells: A3 steel;

Track: 304 stainless steel;

Chain: 304 stainless steel;

Chain wheel: 304 stainless steel;

Roller: 304 stainless steel/990 pieces;

Mesh belt: 80 mesh mesh mesh/304 stainless steel;

Material blocking plate: 304 stainless steel/δ=1.5mm;

Cleaning device: 304/component/5 sets;

　　4Cleaning, air intake, and dehumidification parts:

Circulating fan: 304/component/4-72-6A/5.5kw/5 units;

Moisture exhaust fan: A3 steel/component/4-72-4.5A/7.5kw/1 set;

Moisture removal pipeline and air volume regulating valve: 304 stainless steel;

Cyclone separator: 304 stainless steel/bracket made of A3 steel;

Discharge fan: 304/component/3L/0.75kw;

Inspection door: Inner 304, outer A3 steel/5 panels;

Cleaning device: 3 sets of 304 stainless steel;

Install a drainage channel at the bottom of the discharge end;

Electrical control cabinet: A3 spray painted cabinet body/electrical components made of domestic Chint Electric;

The temperature control instrument is made in Yuyao, Zhejiang;

When the equipment is unloaded, the temperature difference inside the equipment shall not exceed ± 10 ℃ (excluding the inlet and outlet areas);

The supplier is responsible for connecting wires, cables, and cable trays between devices that exceed 10 meters;

Auxiliary materials: welding rods, flanges, screws, paint, etc;

　　Continuous belt dryer for dried bamboo shoots